With lexan window in top plate) do not use remote keypads. CV2, CVP, 3VS some 5VS and some MK dynos (models The keypad can beĪttached to the left vertical column. Keypad cable plugs in the bottom port on the keypad. On models equipped with remote keypad, connect the remote keypad (it may already beĬonnected) to the dyno using the keypad extender cable that exits the dyno top plate on the left.Connect the monitor cable to the monitor port on the back of the computer.Connect the monitor’s power cable to the power inlet on the back of the monitor and the other.Connect the computer’s power cable to the power inlet on the back of the computer and the other.If needed, refer to the manufacturer supplied User’s Guide accompanying Never work inside the computer without unplugging the system. NOTE: Roehrig dynamometers made for customers in countries other than the US could have different power requirements and should not be wired until proper supply voltages have been verified by an REI representative.ĭANGER! - DO NOT TURN YOUR SYSTEM ON UNTIL ALL CONNECTIONS ARE MADE.ĬAUTION! - To help avoid damage to the computer be sure the voltage selection switch is set according to your location. A 220-Volt power box with a 30 Amp breaker is also required to supply power to the motor. customers will need a 110-Volt, (other countries may use 220 volt) surge-protected power strip with 4 open sockets.
If you are unsure of any power connections, please call for further instruction. For systems using customer supplied computers follow the software installation instructions appendix C and D in the back of the software user manual.
All you need to do is connect your system and supply power to theĭynamometer. Before your new system left our facility, Roehrig Engineering configured the hardware and installed the
0 kommentar(er)
